Claude Code | Wobbl

Terminal

$ wobbl setup --no-solvers --agents claude

What setup does

When the claude command is on your PATH, setup runs it to register the server at user scope, removing any older Wobbl entry first.

Terminal

$ claude mcp add --scope user wobbl -- /full/path/to/wobbl mcp

When the command is missing, setup writes the same server into ~/.claude.json under mcpServers.wobbl as a stdio server instead. Either way, the skill goes to ~/.claude/skills/wobbl/SKILL.md. Restart Claude Code and ask it about a part.

By hand

If you would rather not run setup, this one line registers the server by hand.

Terminal

$ claude mcp add --scope user wobbl -- "$(command -v wobbl)" mcp

The skill ships inside the package at wobbl/skill/SKILL.md, and setup is still the easiest way to put it in place, since it copies the file and records it for wobbl uninstall.

Long studies

Strength studies take one to seven minutes. If Claude Code stops waiting before a study finishes, raise its MCP tool timeout, which is in milliseconds, when you start it.

Terminal

$ MCP_TOOL_TIMEOUT=900000 claude

Wobbl keeps itself bounded as well. Every study has a time budget, 300 seconds by default, and when it runs out the last finished mesh level comes back with its checks, so the agent always gets an answer with a confidence that matches it.

Check and remove

wobbl doctor shows agent claude as ok when both the server and the skill are in place. wobbl uninstall --agents claude runs claude mcp remove --scope user wobbl, removes the entry from ~/.claude.json and deletes the skill folder.